This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Micro-Reactor HC-SCR System and the Evaluation of NOx Reduction Characteristics
Technical Paper
2015-01-2021
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
To reduce NOx emissions from diesel engines, the urea-SCR (selective catalytic reduction) system has been introduced commercially. In urea-SCR, the freezing point of the urea aqueous solution, the deoxidizer, is −11°C, and the handling of the deoxidizer under cold weather conditions is a problem. Further, the ammonia escape from the catalyst and the generation of N2O emissions are also problems. To overcome these disadvantages of the urea-SCR system, the addition of a hydrocarbon deoxidizer has attracted attention. In this paper, a micro-reactor SCR system was developed and attached to the exhaust pipe of a single cylinder diesel engine. With the micro-reactor, the catalyst temperature, quantity of deoxidizer, and the space velocity can be controlled, and it is possible to use it with gas and liquid phase deoxidizers. The catalyst used in the tests reported here is Ag(1wt%)-γAl2O3. First, three gas phase hydrocarbons, LPG, ethylene, DME (Di-methyl ether), were evaluated as deoxidizers. The NOx reduction by DME started around 300 °C catalyst inlet temperature, and 90% of NOx reduction was achieved above 400 °C. The reactivity of ethylene and LPG as the deoxidizer is low, and a higher catalyst inlet temperature, above 450 °C, is required for the SCR to become active. As a liquid deoxidizer, the using of the diesel fuel as a deoxidizer is interesting, but the vaporization of the diesel fuel is a problem for the HC-SCR system. The n-heptane, that has a higher volatility but the same cetane number as diesel fuel, was sometimes used as an alternative of diesel fuel for the combustion research, and applied in this research to investigate the diesel fuel performance as a deoxidizer. The catalyst inlet temperature to achieve 80% of NOx reduction at SV=25000 hr−1 was 400 °C, however, at 350 °C 80% NOx reduction was possible for SV=12500 hr−1. The space velocity of the catalyst is closely related to the NOx reduction performance.
Authors
Topic
Citation
Shibata, G., Takahara, M., Nishikawa, K., and Ogawa, H., "Development of a Micro-Reactor HC-SCR System and the Evaluation of NOx Reduction Characteristics," SAE Technical Paper 2015-01-2021, 2015, https://doi.org/10.4271/2015-01-2021.Also In
References
- Shibata , G. , Tanaka , K. , Chiba , Y. , and Ogawa , H. NOx reduction characteristics of DME-SCR System for Diesel Engines Paper# EE-1 in COMODIA 2012 2012 Fukuoka
- Simokawabe , M. , Ogawa , H. , Nakajima , Y. and Seto , HC 2009 Fundamental research on the reduction device for a diesel engine exhaust gas.
- Viola M. B. 2009 HC-SCR Catalyst Performance in Reducing NOx Emissions from a Diesel Engine Running Heavy Duty Transient Test Cycles with Diesel Fuel and Ethanol as the Reductants. SAE Technical Paper. 2009-01-2775
- Schmieg , S. Aspects of HC-SCR Catalyst Durability for Lean-Burn Engine Exhaust Aftertreatment SAE Int. J. Fuels Lubr 3 2 691 709 2010 10.4271/2010-01-2160