This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Composites Assembly and Fastening Automating Grip Length Measurements to Generate a True As-Built Kit List

Journal Article
2012-01-1889
ISSN: 1946-3855, e-ISSN: 1946-3901
Published September 10, 2012 by SAE International in United States
Composites Assembly and Fastening Automating Grip Length Measurements to Generate a True As-Built Kit List
Sector:
Citation: Richardson, R. and Stewart, T., "Composites Assembly and Fastening Automating Grip Length Measurements to Generate a True As-Built Kit List," SAE Int. J. Aerosp. 5(1):97-100, 2012, https://doi.org/10.4271/2012-01-1889.
Language: English

Abstract:

With composite skins and structures, the exact thickness of a part stack is indeterminate, and thus the fastener grip length for any particular hole cannot be known with certainty, from engineering data alone. A common practice on the assembly line is to provide “overs and unders” - that is, one or two grips lengths above and below the expected fastener length. Unless all of the fasteners are kept line-side which slows production operations, pre-kitted fasteners will require a tremendous amount of return-to-stock. Test fitting every fastener before sealant application and/or delivering 200-400% more fasteners than are needed for the task are not a good value for production.
This paper will discuss the development processes and production applications of making fast, accurate stack thickness measurements that are correlated to each particular hole, creating the as-built kit list, and then delivering the kitted fasteners to the production line in the order that they will be installed. With every fastener location known to have the exact grip length required for its as-built condition, production line workers can stay strictly focused on value-added work. The ability to grip up to 40 fastener locations per minute allows the technician to move at an increased rate during the measurement process. By simplifying the installation and semi-automating the measurement, the assembly process can see immediate improvements.