This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Explication of Gasket for Sealing of Super Rough Surface
Technical Paper
2012-01-0958
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The research study experimented and analyzed the relation between a super rough surface and the seal of the gasket. It groped for the relation of the seal by the seal testing and FEM by using several different type of jig and gaskets. As for the seal of the gasket, the thing that greatly depends on the contact range and seal side has been understood. The improvement of the seal was tried by using not only upper and lower sides but also sides that were the concepts of a general seal as a sealing surface.
Recommended Content
Authors
Citation
Nagata, A., Ushijima, S., Mukai, S., and Hayashi, E., "Explication of Gasket for Sealing of Super Rough Surface," SAE Technical Paper 2012-01-0958, 2012, https://doi.org/10.4271/2012-01-0958.Also In
References
- Chugoku Bureau of Economy Trade and Industry: FY2008, Regional Revitalization Survey, Survey on Regional Cooperation in the Automotive Industries in the Chugoku and Kyushu Regions, P2 2008
- Yamamoto, Yuji et al Introduction to Seal Technology Kogyo Chosakai Publishing 2008
- Okamura, T. Ohtsuka, M. Suetsugu, N. Ohta, T. et al. “Micro Surface Roughness of O-rings and Sealing Mechanism,” SAE Technical Paper 2002-01-0662 2002 10.4271/2002-01-0662
- Otsuka, M. Okamura, T. Suetsugu, N. Ohta, T. et al. “A New Concept of Static Rubber Gasket for Sealing Rough Surface,” SAE Technical Paper 2003-01-0485 2003 10.4271/2003-01-0485
- NOK Standard Products Technical Note, NOK,P138 2011