This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Study on Warpage of Large and Thin-Wall Injection Molded Part
Technical Paper
2012-01-0947
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Generally, it is difficult to compare the warpage of CAE simulation with which of physical part directly for large, thin-wall injection molded part. The warpage of an injection molded automotive interior door panel was discussed in this paper. The CAE simulation result was obtained via analysis in Autodesk Moldflow software with a reasonable CAE model which was constrained according to the physical measurement, and in the physical measurement, several points' positions were confirmed to make sure that the part was fixed on the gauge correctly and consistently. Finally, the warpage result of CAE simulation showed a good consistency with which was measured with a three-coordinate measuring machine.
Recommended Content
Authors
Citation
Guo, X. and Guo, Q., "Study on Warpage of Large and Thin-Wall Injection Molded Part," SAE Technical Paper 2012-01-0947, 2012, https://doi.org/10.4271/2012-01-0947.Also In
References
- Shoemaker, J. Moldflow Design Guide Moldflow Corporation USA 2006
- Friedl, C. Burke, H. Kennedy, P. McCaffrey, N. Thomas, R. SWIS 0.3 Manual Moldflow Pty. Ltd. Melbourne, Australia 1990
- Baaijens, F.P.T. Calculation of residual stress in injection moulded products Rheol. Acta 30 284 299 1991
- Douven, L.F.A. Baaijens, F.P.T. Meijer, H.E.H. The computation of properties of injection-moulded products Progress in Polymer Science 20 403 457 1995
- Choi, Du-Soon Im, Yong-Tae Prediction of shrinkage and warpage in consideration of residual stress in integrated simulation of injection molding Composite Structures 47 655 665 1999
- Kennedy, P.K. Practical and Scientific Aspects of Injection Molding Simulation 2008