This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Influence of backpressure's Measurement Method on Exhaust System Development and its Acoustics Package
Technical Paper
2010-36-0094
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The present article shows the influence of the measurement method on a transversal section of exhaust system, downstream of the manifold, the dimensional and the acoustics package simulation. For this task the same system section was instrumented with five different configurations; the values of backpressure were measured on maximum power and used as data for the GTPOWER software to make a virtual simulation of acoustics intensity as a function of engine speed. Therefore it was possible to compare the virtual curves with the real measured values of acoustics intensity. Due to the stream lines influence of the analyzed section, we obtained different values of backpressure and curves of acoustics intensity. Finally, it is shown the measured value of backpressure which has the best correlation with the real measurement and identifies the measurement method with piezo ring as the best configuration.
Recommended Content
Authors
Citation
de Oliveira Silva, R., Rudge, A., da Silva de Amorim, O., and Folco, J., "Influence of backpressure's Measurement Method on Exhaust System Development and its Acoustics Package," SAE Technical Paper 2010-36-0094, 2010, https://doi.org/10.4271/2010-36-0094.Also In
References
- Kamal, A. R. Ismail Dr. Técnicas de Medidas e Instrumentação 2003 2nd
- Hill, Bill David, R. Dowling Dr. Exhaust System & Backpressure Tenneco 2008
- ABNT NBR 15145 ABNT 2004
- ABNT NBR 9714 ABNT 2000
- CONAMA 01, de 11 de fevereiro de 1993
- CONAMA 272, de 14 de setembro de 2000