This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effect of Injection Pressure and Ethyl Acetate Additive on Performance and Emissions of Water Diesel Emulsion Fueled DI Diesel Engine
Technical Paper
2010-01-1965
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
A number of attempts are being made to conserve fossil fuels. The diesel engine, because of its better fuel economy and lower maintenance cost has become the dominant in the field of transportation, agricultural and industrial sectors. Simultaneous reduction of emissions of both oxides of nitrogen (NOx) and particulate matter from diesel engine is very difficult. This can be achieved by using water diesel emulsion, increased injector opening pressure and oxygenated fuel additive. Ethyl acetate was used as an additive as well as oxygenated compound to keep the blends in homogeneous, stable state and to promote combustion due to the inherent oxygen in the fuel molecule. The effects of water diesel emulsion, increasing injector opening pressure and ethyl acetate addition on engine's fuel economy and emissions were studied on a single-cylinder DI diesel engine. The experimental results show that percentage of water in emulsion can be enhanced by increasing the injection pressure and use of oxygenated fuel. The engine emissions of CO, HC, smoke density and NOx were reduced when injector opening pressure increased and ethyl acetate was added in diesel oil. Use of the emulsions also resulted in decrease in BSEC.
Recommended Content
Authors
Topic
Citation
Wadawadagi, S. and Reddy PhD, V., "Effect of Injection Pressure and Ethyl Acetate Additive on Performance and Emissions of Water Diesel Emulsion Fueled DI Diesel Engine," SAE Technical Paper 2010-01-1965, 2010, https://doi.org/10.4271/2010-01-1965.Also In
References
- Joyce, J.R. The Atomization of Liquid Fuels for Combustion Journal of the Institute of Fuel 1949
- Rizk, N.K. Lefebvre, A.H. “Influence of Liquid Properties on the Internal Flow Characteristics of Simple Swirl Atomizers” The American Society of Mechanical Engineers
- Nishimura, T. Satoh, K. Takahashi, S. Yokota, K. “Effect of Fuel Injection Rate on Combustion and Emission in a DI Diesel Engine,” SAE Technical Paper 981929 1998 10.4271/981929
- Alriksson, M. Gjirja, S. Denbratt, I. “The Effect of Charge Air and Fuel Injection Parameters on Combustion With High Levels of EGR in a HDDI Single-Cylinder Diesel Engine,” SAE Technical Paper 2007-01-0914 2007 10.4271/2007-01-0914
- Yamane, K. Uetam A. Shimamoto, Y. “Influence of physical and chemical properties of bio-diesel fuels on injection, combustion and exhaust emission characteristics in a direct injection compression ignition engine” International Journal of Engine Research 2 4 249 261 2001
- Celikten, I. “An experimental investigation of the effect of the injection pressure on the engine performance and exhaust emission in indirect injection diesel engines” Applied Thermal Engineering 23 2051 60 2003
- Cingur, Y. Altiparmak, D. “Effect of cetane number and injection pressure on a DI diesel engine performance and emissions” Energy Conversion and Management 44 389 97 2003
- Hountalas, D.T. Kouremenos, D.A. Binder, K.B. Schwarz, V. et al. “Effect of Injection Pressure on the Performance and Exhaust Emissions of a Heavy Duty DI Diesel Engine,” SAE Technical Paper 2003-01-0340 2003 10.4271/2003-01-0340
- Crookes, R.J. Nazha, M.A.A. Janota, M.S. Storey, T. “Investigation into Combustion of Water/Diesel Fuel Emulsions,” SAE Technical Paper 800094 1980 10.4271/800094
- Tsao, K.C. Wang, C.L. “Puffing and Micro-Explosion Phenomena of Water Emulsion Fuels,” SAE Technical Paper 860304 1986 10.4271/860304
- Jamil, G. Damon, H. Khaled, Al-K. “Performance, Emissions and Heat Release Characteristics of Direct Injection Diesel Engines Operating on Diesel Oil Emulsions” 2006
- Murayama, T. Morishima, Y. Tsukahara, M. Miyamato, N. “Experimental Reduction of NOx, Smoke and BSFC in a Diesel Engine using Uniquely Produced Water (0-80%) to Fuel Emulsion,” SAE Technical Paper 780224 1978 10.4271/780224
- Zwillenberg, M.L. Sengupta, C. Guerra, C.R. “Water Oil emulsion Combustion in Boilers and Gas turbines” Proceedings International Conference on Ash Deposits and Corrosion due to Impurities in combustion gases 335 355 1977
- Senthil, K.M. Kerihuel, A. Bellettre, J. Tazerout, M. “A Comparative Study of Different methods of Using Animal Fat as a fuel in a Compression Ignition Engine” Journal of Engineering for Gas Turbines and Power 128 907 914 2006
- Chikahisa, T. Miyamoto, N. Murayama, T. “Smokeless, Low NOx, and Low Noise Diesel Combustion with Methanol as a Main Fuel,” SAE Technical Paper 811375 1981 10.4271/811375
- Odaka, M. Koike, N. Tsukamoto, Y. Narusawa, K. “Optimizing Control of NOx and Smoke Emissions from DI Engine with EGR and Methanol Fumigation,” SAE Technical Paper 920468 1992 10.4271/920468
- Zhang, G.D. Liu, H. Xia, X.X. Zhang, W.G. Fang, J.H. “Effects of Di Methyl Carbonate fuel additive on Diesel Engine Performances” Proceedings of the I MECH E Part D Journal of Automobile Engineering D7 897 903 2005
- Gong, Y. Liu, S. Guo, H. Hu, T. Zhou, L. “A new diesel oxygenate additive and its effects on engine combustion and emissions” Applied thermal engineering 27 202 207 2007
- Choi, C.Y. Bower, G.R. Reitz, R.D. “Effects of Bio-diesel Blended fuels and Multiple Injections on D.I. Diesel Engines,” SAE Technical Paper 970218 1997 10.4271/970218
- Agarwal, A.K. Das, L.M. “Bio-diesel development and Characterization for use as a Fuel in compression Ignition Engines” Transaction of the ASME, Journal of Engineering for Gas Turbines and Power 123 40 447 2001
- Christensen, R. Sorenson, S.C. Jensen, M.G. Hansen, K.F. “Engine Operation on Dimethyl Ether in a Naturally Aspirated, DI Diesel Engine,” SAE Technical Paper 971665 1997 10.4271/971665
- Bhattachrya, T.K. Ram, C. Mishra, T.N. “Performance characteristics of a stationary constant speed compression ignition engine on alcohol-diesel micro emulsions” Agricultural Engineering International: the CIGR Ejournal VIII 2006
- Shi, X. Yu, Y. He, H. Shuai, S. Wang, J. Li, R. “Emission characteristics using methyl soyate-ethanol-diesel fuel blends on a diesel engine” Fuel 84 1543 1549 2005
- Xiaoyan, S. Xiaobing, P. Yujing, M. Hong, H. Shijin, S. Jianxin, W. Hu, C. Rulong, Li. “Emission reduction potential of using ethanol-biodiesel-diesel fuel blend on a heavy-duty diesel engine” Atmospheric Environment 40 2567 2574 2006
- Hu, C. Jianxin, W. Shijin, S. Wenmiao, C. “Study of Oxygenated biomass fuel blends on a diesel engine” Fuel xxx xxx xxx 2008
- Hadirahimi, B. G. Talal, Y. Gholamhasan, N. Mahdi, K. “Diesterol: An environment-friendly IC engine fuel” Renewable Energy 34 335 342 2009
- Mustafa, C. Cenk, S. Ahmet, N. O. Ali T. “Effect of Injection Pressure on the Combustion, Performance, and Emission Characteristics of a Diesel Engine Fueled with Methanol-blended Diesel Fuel” Energy and Fuels ACS
- Chandan, K. Athawe, M. Aghav, Y.V. Gajendra Babu, M.K. et al. “Effects of Ethanol Addition on Performance, Emission and Combustion of DI Diesel Engine Running at Different Injection Pressures,” SAE Technical Paper 2007-01-0626 2007 10.4271/2007-01-0626
- Lee, C.-F.F. Wang, K.-T. Cheng, W.L. “Atomization Characteristics of Multi-component Bio-fuel Systems under Micro-explosion Conditions,” SAE Technical Paper 2008-01-0937 2008 10.4271/2008-01-0937
- Hashimoto, M. Dan, T. Asano, I. Arakawa, T. “Combustion of the Rape-Seed Oil in a Diesel Engine,” SAE Technical Paper 2002-01-0867 2002 10.4271/2002-01-0867
- Venkanna, K.B. Wadawadagi, S.B. Venkataramana Reddy, C. “Effect of Injection Pressure on Performance, Emission and Combustion Characteristics of Direct Injection Diesel Engine Running on Blends of Pongamia Pinnata Linn Oil (Honge oil) and Diesel Fuel” Agricultural Engineering International: The CIGR Ejournal XI 1 17 2009
- Venkanna, K.B. Venkataramana Reddy, C. Wadawadagi, S.B. “Performance, Emission and Combustion Characteristics of Direct Injection Diesel Engine Running on Rice Bran Oil / Diesel Fuel Blend” International Journal of Chemical and Biomolecular Engineering 2 131 137 2009
- Venkanna, K.B. Venkataramana, C.R. “Effect of injector opening pressures on the performance, emission and combustion characteristics of DI diesel engine running on calophyllum inophyllum linn oil (honne oil) / diesel fuel blend” Thermal Science 15 XXX XXX 2011
- Ahmed, I. “Oxygenated Diesel: Emissions and Performance Characteristics of Ethanol-Diesel Blends in CI Engines,” SAE Technical Paper 2001-01-2475 2001 10.4271/2001-01-2475
- Kadota, T. Yamasaki, H. “Recent advances in the combustion of water fuel emulsion” Progress in Energy and Combustion Science 28 385 404 2002