This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Influence of Fuel Injection Rate on the Performance, Emission and Combustion Characteristics of DI Diesel Engine Running on Calophyllum Inophyllum Linn Oil (Honne Oil) / Diesel Fuel Blend
Technical Paper
2010-01-1961
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The present work examines the use of a non-edible vegetable oil namely honne oil, a new possible alternative fuel for diesel engine. High viscosity of honne was reduced by blending it with diesel fuel. A direct injection (DI) diesel engine typically used in agricultural sector was operated on neat diesel (ND) and a blend of 50% honne oil with 50% diesel fuel (H50). Rate of injection of fuel was changed (by changing plunger diameter) to study the performance, emission and combustion characteristics. For the blend (H50), increasing the plunger diameter (PD) from the manufacturer specified plunger diameter (8 mm) increased the brake thermal efficiency and reduced CO, HC, smoke opacity and NOx emissions. However, brake thermal efficiency, CO and HC emissions at 10 mm PD were higher with H50 compared to ND (8 mm PD). Smoke opacity and NOx emissions at 10 mm PD were marginally lower for H50 compared to ND. The ignition delay with H50 was decreased as PD was increased. Improved premixed heat release rate was observed with H50 when the PD was increased. The best PD was found to be 10 mm for H50 based on brake thermal efficiency.
Authors
Topic
Citation
Belagur, V. and Reddy PhD, V., "Influence of Fuel Injection Rate on the Performance, Emission and Combustion Characteristics of DI Diesel Engine Running on Calophyllum Inophyllum Linn Oil (Honne Oil) / Diesel Fuel Blend," SAE Technical Paper 2010-01-1961, 2010, https://doi.org/10.4271/2010-01-1961.Also In
References
- Heywood, J.B. Internal Combustion Engines, International Edition McGraw-Hill New York 1988
- Lichty, L.C. 1967 ‘Combustion engine processes’ New York McGraw-Hill Book Company
- Tat, M.E. Gerpen, J.V. “The kinematic viscosity of biodiesel and its blends with diesel fuels” JAOCS 76 1511 1513 1999
- Joshi, R.M. Pegg, M.J. “Flow properties of biodiesel fuel blends at low temperatures” Fuel 8 143 51 2007
- Nwafor, O.M.I. Rice, G. “Performance of rapeseed oil blends in diesel engines” Journal of Applied Energy 54 345 1996
- Tat, M.E. Gerpen, J.V. “The specific gravity of bio-diesel and its blends with diesel fuels” JAOCS 77 115 119 2000
- Bahadur, N.P. Boocock, D.G.B. Konar, S.K. 1995 “Liquid hydrocarbons from catalytic pyrolysis of sewage sludge lipid and canola oil: evaluation of fuel properties” Energy & Fuels 9 248 56 1995
- Varde, K.S. “Bulk modulus of vegetable oil-diesel fuel blends” Fuel 63 713 5 1984
- Boehman, A.L. Morris, D. Szybist, J. “The impact of the bulk modulus of Diesel fuels on fuel injection timing” Energy & Fuels 18 1877 82 2004
- Rakopoulos, C.D. Antonopoulos, K.A. Rakopoulos, D.C. “Multi-zone modeling of Diesel engine fuel spray development with vegetable oil, bio-diesel or Diesel fuels” Energy Conversion and Management 47 1550 73 2006
- Rakopoulos, C.D. Antonopoulos, K.A. Rakopoulos, D.C. Hountalas, D.T. Giakoumis, E.G. “Comparative performance and emissions study of a direct injection Diesel engine using blends of diesel fuel with vegetable oils or bio-diesel of various origins” Energy Conversion and Management 47 3272 3287 2006
- Wong, C.L. Steere, D.E. “The Effects of Diesel Fuel Properties and Engine Operating Conditions on Ignition Delay,” SAE Technical Paper 821231 1982 10.4271/821231
- Arai, M. Tabata, M. Hiroyasu, H. Shimizu, M. “Disintegration Process and Spray Characterization of Fuel Jet Injected by a Diesel Nozzle,” SAE Technical Paper 840275 1984 10.4271/840275
- Kamimoto, T. Matsuoka, S. “Prediction of Spray Evaporation in Reciprocating Engines,” SAE Technical Paper 770413 1977 10.4271/770413
- Desantes, J.M. Arrègle, J. Ruiz, S. Delage, A. “Characterization of the Injection-Combustion Process in a D.I. Diesel Engine Running with Rape Oil Methyl Ester,” SAE Technical Paper 1999-01-1497 1999 10.4271/1999-01-1497
- Schlick, M.L. Hanna, M.A. Scinstock, J.L. “Soya bean and sunflower oil performance in a diesel engine” Transactions of ASAE 31 1345 9 1988
- Agarwal, A.K. Bijwe, J. Das, L.M. “Effect of bio-diesel utilization of wear of vital parts in compression ignition engine” Journal of Engineering for Gas Turbine and Power Transactions of the ASME 125 604 611 2003
- Raheman, H. Phadatare, A.G. “Diesel Engine Emissions and Performance from Blends of Karanja Methyl Ester and Diesel” Biomass and Bioenergy 27 393 397 2004
- Bajpai, S. Sahoo, P.K. Das, L.M. “Feasibility of blending karanja vegetable oil in petro-diesel and utilization in a direct injection diesel engine” Fuel 88 705 711 2009
- Agarwal, A.K. Rajamanoharan, K. “Experimental Investigations of Performance and Emissions of Karanja oil and its blends in a single cylinder agricultural, diesel engine” Applied Energy 86 106 112 2009
- Nishimura, T. Satoh, K. Takahashi, S. Yokota, K. “Effect of Fuel Injection Rate on Combustion and Emission in a DI Diesel Engine,” SAE Technical Paper 981929 1998 10.4271/981929
- Kouremenos, D.A. Hountalas, D.T. Kouremenos, A.D. “Experimental Investigation of the Effect of Fuel Composition on the Formation of Pollutants in Direct Injection Diesel Engines,” SAE Technical Paper 1999-01-0189 1999 10.4271/1999-01-0189
- Cigizoglu, K.B. Ozaktas, T. Karaosmanoglu, F. “Used sunflower oil as an alternative fuel for diesel engines” Energy Sources 19 559 66 1997
- Lee, C.S. Park, S.W. Kwon, S.I.L. “An experimental study on the atomization and combustion characteristics of bio-diesel-blended fuels” Energy and Fuels 19 2201 8 2005
- Ejim, C.E. Fleck, B.A. Amirfazli, A. “Analytical study for atomization of bio-diesels and their blends in a typical injector: surface tension and viscosity effects” Fuel 86 1534 44 2007
- Alriksson, M. Gjirja, S. Denbratt, I. “The Effect of Charge Air and Fuel Injection Parameters on Combustion With High Levels of EGR in a HDDI Single-Cylinder Diesel Engine,” SAE Technical Paper 2007-01-0914 2007 10.4271/2007-01-0914
- Yamane, K. Uetam, A. Shimamoto, Y. “Influence of physical and chemical properties of bio-diesel fuels on injection, combustion and exhaust emission characteristics in a direct injection compression ignition engine” International Journal of Engine Research 2 4 249 261 2001
- Celikten, I. “An experimental investigation of the effect of the injection pressure on the engine performance and exhaust emission in indirect injection diesel engines” Applied Thermal Engineering 23 2051 60 2003
- Cingur, Y. Altiparmak, D. “Effect of cetane number and injection pressure on a DI diesel engine performance and emissions” Energy Conversion and Management 44 389 97 2003
- Hountalas, D.T. Kouremenos, D.A. Binder, K.B. Schwarz, V. et al. “Effect of Injection Pressure on the Performance and Exhaust Emissions of a Heavy Duty DI Diesel Engine,” SAE Technical Paper 2003-01-0340 2003 10.4271/2003-01-0340
- Venkanna, B.K. Wadawadagi, S.B. Venkataramana Reddy, C. “Effect of Injection Pressure on Performance, Emission and Combustion Characteristics of Direct Injection Diesel Engine Running on Blends of Pongamia Pinnata Linn Oil (Honge oil) and Diesel Fuel” Agricultural Engineering International: The CIGR Ejournal XI 1 17 2009
- Venkanna, B.K. Venkataramana Reddy, C. Wadawadagi, S.B. “Performance, Emission and Combustion Characteristics of Direct Injection Diesel Engine Running on Rice Bran Oil / Diesel Fuel Blend” International Journal of Chemical and Biomolecular Engineering 2 131 137 2009
- Venkanna, K.B. Venkataramana, C.R. “Effect of injector opening pressures on the performance, emission and combustion characteristics of DI diesel engine running on calophyllum inophyllum linn oil (honne oil) / diesel fuel blend” Thermal Science 15 XXX XXX 2011
- Haldar, S.,K, Ghosh, B.B. Nag, A. “Utilization of unattended Putranjiva roxburghii non-edible oil as fuel in diesel engine” Renewable Energy 34 343 347 2009
- Purushothaman, K. Nagarajan, G. “Performance, emission and combustion characteristics of a compression ignition engine operating on neat orange oil” Renewable Energy 34 242 245 2009
- Venkanna, K.B. Venkataramana Reddy, C. “Performance and emission characteristics of calophyllum inophyllum linn oil (blends and preheated) in an agricultural diesel engine” International Journal of Renewable Energy Technology X Y 000 000 xxxx
- Venkanna, K.B. Venkataramana Reddy, C. “Performance, emission and combustion characteristics of DI diesel engine running on blends of calophyllum inophyllum linn oil (honne oil) /diesel fuel / kerosene” International Journal of Renewable Energy Technology X Y 000 000 xxxx
- Venkanna, K.B. Venkataramana Reddy, C. “Biodiesel production and optimization from calophyllum inophyllum linn oil (honne oil) - A three stage method” Bioresource Technology 100 5122 5125 2009