This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Stress Analysis and Strength Evaluation of Bonded Shrink Fitted Joints Subjected to Torsional Loads
Technical Paper
2000-01-0426
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2000 World Congress
Language:
English
Abstract
This paper deals with stress analysis and strength evaluation of bonded shrink fitted joints subjected to torsion. The stress distributions in the adhesive layer of bonded shrink fitted joints are analyzed by using the axisymmetric theory of elasticity when an external torsion is applied to the upper end of shaft. The effect of the outer diameter and the stiffness of rings on the interface stress distributions are clarified by the numerical calculations. Using the interface stress distributions, joint strength is predicted. In addition, joint strength was measured experimentally. It is seen that a rupture of adhesive layer is initiated from the upper edge of the interfaces when a torsion is applied to the upper end of shaft. The numerical result are in fairly good agreement with the experimental results. It is found that the joint strength of bonded shrink fitted joints is greater than that of shrink fitted joints.
Authors
Citation
Yoneno, M., Sawa, T., and Motegi, Y., "Stress Analysis and Strength Evaluation of Bonded Shrink Fitted Joints Subjected to Torsional Loads," SAE Technical Paper 2000-01-0426, 2000, https://doi.org/10.4271/2000-01-0426.Also In
References
- Conway, H.d. Farnham K.A. Contact Stresses between Cylindrical Shafts and Sleeves Int. J. Engng. Sci. 5 541 554 1967
- Conway, H.d. Farnham, K.A. The Shrink Fit of Flexible Sleeve on a Shaft Int. J. Mech. Sci. 10 757 764 1968
- Kato, K. Kayaba, T. Nitta, I. Shimoda, S. The Effect of Surface Roughness on Fitting Strength of Shrink Fit between Ceramic and Elements Trans. ASME. 111 318 325 JULY 1989
- Oda. J. Shibahara, M. Miyamoto, H. On Shrink-Fit Stresses between an Infinite Cylinder and a Finite Hollow Cylinder and a Finite Hollow Cylinder Bull. JSME. 15 88 1147 1155 1972
- Persons. B. Wilson, E.A. A Method for Determining the Surface Contact Stresses Resulting from Interference Fits Trans. ASME, FEE 1970 208 218
- Erdogan. F. Gupta, G.D. The load Transfer Problem in Shafts Coupled Through a Sleeve Trans. ASME DEC 1973 997 1003
- Erdogan. F. Gupta, G.D. The Torsion Problem of a Disk Bonded to a Dissimilar Shaft Int. J. Solids Structures 8 1972 93 l09
- Yoneno, M. Sawa, T. Shimotakahara, K. Motegi, Y. Push-off Test and Strength Evaluation of Joints Combining Shrink Fitting with Bonding proceedings of Experimental Mechanics: Advances and Applications 193 1996 193 198
- Hattori, T. et Trans. JSME 47 415 1981 264 274