This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Plastic Throttle Body
Technical Paper
2000-01-0046
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2000 World Congress
Language:
English
Abstract
Since the large scale production of plastic throttle bodies in 1994 there have been a number of further introducions. However the universal adaptation of plastic for the throttle body has not yet occurred. This paper will describe design approaches and processing solutions to facilitate low cost precision manufacturing with test results of actual parts made by these approaches.
Introductions:
1994 U.K. 4 cylinder engine, cable operation
1998 Germany 4 cylinder engine, cable operation
1999 U.S. 4 cylinder engine cable operation
Recommended Content
Authors
Citation
Daly, P. and Vanderveen, J., "Development of a Plastic Throttle Body," SAE Technical Paper 2000-01-0046, 2000, https://doi.org/10.4271/2000-01-0046.Also In
References
- SAE 840540 Integrated Engine Control- The Next Step in Electronic Engine Technology Laurent, Daly, Ang
- Federal Motor Vehicle Safety Standard FMVSS 301
- “Throttle shaft and plate construction” Becker Christine
- NHTSA website www.dot.gov./affairs/nhtsain.htm
- SAE Paper 760242 “The Electronic Control Unit for Production Electronic Fuel Injection Systems” Rivard J.G.
- SAE Paper 950228 “Development of The First Volume Production Thermoplastic Throttle Body” Hughes S. Welch, M. Sanghera G.
- SAE Paper 1999-01-0316 “Thermoplastic Materials for Throttle Body Applications” Smithson Jim
- SAE Paper 950484 “An Evaluation of Factors Affecting Circularity of Injection Molded Thermoplastic Underhood Components” Redding Suzanne
- Autoplas 1996 “A Thermoplastic Throttle Body for an Integrated Air Fuel Module.” Becker, Milne
- “Throttle body”