This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Real-Time Steady-State Oil Consumption Measurement on Commercial SI-Engine
Technical Paper
1999-01-3461
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The oil consumption has been measured in real-time for steady-state operating conditions for an approximately 2 L SI-engine. These oil consumption measurements have been obtained for the engine stack (total) as well as for the individual engine cylinders with the current generation of Southwest Research Institute (SwRI) developed SO2 analyzers. The 10 steady-state data presented in this paper is only a small fraction of the 234 steady-state data taken as part of this project. This paper is important since few complete data sets have been published in this area of research and since it illustrates the technical superiority of this analyzing tool for engine development purposes.
Recommended Content
Authors
Citation
Froelund, K., "Real-Time Steady-State Oil Consumption Measurement on Commercial SI-Engine," SAE Technical Paper 1999-01-3461, 1999, https://doi.org/10.4271/1999-01-3461.Also In
References
- Thom, R. Kollmann, K. Warnecke, K. Frend, M. “Extended Oil Drain Intervals: Conservation of Resources or Reduction of Engine Life” SAE Paper 951035
- Sachdev, R. Wong, V. W. Shahed, S. M. “Effect of Ash Accumulation on the Performance of Diesel Exhaust Particulate Traps” SAE Paper 830182
- Ball, D. J. Kirby, C. W. “A Survey of Automotive Catalyst Technologies Using Rapid Aging Test Schedules Which Incorporate Engine Oil Derived Poisons” SAE Paper 973050
- Irion, E. Land, K. Gurtler, T. Klein, M. “Oil-Quality Prediction and Oil-Level Detection with the TEMIC QLT-Sensor Leads to Variable Maintenance Intervals,” SAE Paper 970847
- Koech, K. “Experience With Oil Consumption Measurements on the Engine Test Bed” SAE Paper 931667
- Haas, A. Geiger, U. Maaben, F. “Oil Aeration in High Speed Combustion Engines” SAE Paper 940792
- Koch, F. Maassen, F. Geiger, U. “Development of Modern Engine Lubricating Systems” SAE Paper 970922
- Koch, F. Decker, P. Guelpen, R. Quadflieg, F. J. Loeprecht, M. “Cylinder Liner Deformation Analysis - Measurements and Calculations” SAE Paper 980567
- Nakashima, K. Ishihara, S. Urano, K. Murata, K. “Lubricating Oil Flow into the Combustion Chamber and its Reduction Method in an Automobile Gasoline Engine” SAE Paper 962034
- Nakayama, K. Watanabe, K. Seki, T. Takiguchi, M. Someya, T. “Effect of Oil Ring Geometry on Oil Film Thickness in Circumferential Direction of Cylinder” SAE Paper 982578
- Saito, K. Igashira, T. Nakada, M. “Analysis of Oil Consumption by Observing Oil Behavior Around Piston Ring Using a Glass Cylinder Engine” SAE Paper 892107
- Froelund, K. Schramm, J. Noordzij, B. Tian, T. Wong, V. W. “An Investigation of the Cylinder Wall Oil Film Development During Warm-Up of an SI-Engine Using Laser Induced Fluorescence” SAE Paper 971699
- Fujimoto, H. Yoshihara, Y. Goto, T. Furuhama, S. “Measurement of Cylinder Bore Deformation During Actual Operating Engines” SAE Paper 910042
- Hitosugi, H. Nagoshi, K. Komada, M. Furuhama, S. “Study on Mechanism of Lubricating Oil Consumption Caused by Cylinder Bore Deformation” SAE Paper 960305
- Nakashima, K. Ishihara, S. Urano, K. “Influence of Piston Ring Gaps on Lubricating Oil Flow into the Combustion Chamber” SAE Paper 952546
- Nakashima, K. Ishihara, S. Urano, K. Murata, K. “Lubricating Oil Flow into the Combustion Chamber and its Reduction Method in an Automobile Gasoline Engine” SAE Paper 962034
- Ingaki, H. Saito, A. Murakami, M. Konomi, T. “Measurement of Oil Film Thickness Distribution on Piston Surface Using the Fluorescence Method” JSME Journal 40 3 1997
- Thirouard, B. P. Hart, D. P. Tian, T. “Investigation of Oil Transport Mechanism in the Piston Ring Pack of a Single Cylinder Diesel Engine, Using Two Dimensional Laser Induced Fluorescence” SAE Paper 982658
- Koch, F. Decker, P. Guelpen, R. Quadflieg, F. J. Loeprecht, M. “Cylinder Liner Deformation Analysis - Measurements and Calculations” SAE Paper 980567
- Schneider, E. W. Blossfeld, D. H. Lechman, D. C. Hill, R. F. Reising, R. F. Brevic, J. E. “Effect of Cylinder Bore Out-of-Roundness on Piston Ring Rotation and Engine Oil Consumption” SAE Paper 930796
- Ostroski, G. M. Ghandhi, J. B. “Development of a Dual Fiber Probe for the Investigation of Oil Transport and Consumption” Paper 99-ICE-195 32-3 ASME 1999
- Tian, T. Wong, V. W. “Modeling the Lubrication, Dynamics, and Effects of Piston Dynamic Tilt of Twin-Land Oil Control Rings in Internal Combustion Engines” 1998 Fall ASME ICE Conference
- Tian, T. Wong, V. W. Heywood, J. B. “Modeling the Dynamics and Lubrication of Three Piece Oil Control Rings in Internal Combustion Engines” SAE Paper 982657
- Tian, T. Rabute, R. Wong, V. W. Heywood, J. B. “Effects of Piston Ring Dynamics on Ring/Groove Wear and Oil Consumption in a Diesel Engine” SAE Paper 970835
- Froelund, K. Schramm, J. Tian, T. Wong, V. W. Hochgreb, S. “Analysis of the Piston Ring/Liner Oil Film Development During Warm-Up for an SI-Engine” 18 th Annual Fall Technical Conference of the ASME Internal Combustion Engine Division 27-2 1996
- Richardson, D. E. “Comparison of Measured and Theoretical Inter-Ring Gas Pressure on a Diesel Engine” SAE Paper 961909
- Hitosugi, H. Nagoshi, K. Komada, M. Furuhama, S. “Study on Mechanism of Lubricating Oil Consumption Caused by Cylinder Bore Deformation” SAE Paper 960305
- Miyachika, M. “An Analytical Evaluation Method for Lubricating Oil Consumption” Proc. Instn Mech Engrs 205 IMechE 1991
- Wahiduzzaman, S. Dursunkaya, Z. Kelley, F. “A Model for Evaporative Consumption of Lubricating Oil in Reciprocating Engines” SAE Paper 922202
- Ariga, S. “Observation of Transient Oil Consumption with In-Cylinder Variables” SAE Paper 961910
- Ariga, S. Sui, P. C. Shahed, S. M. “Instantaneous Unburned Oil Consumption Measurement in a Diesel Engine Using SO2-Tracer Technique” SAE Paper 922196
- Ariga, S. Sui, P. C. Bailey, B. Kumakiri, T. Osumi, Y. Sakamoto, A. “On-Line Oil Consumption Measurement and Characterization of an Automotive Gasoline Engine by SO2- Method” SAE Paper 920652
- Bailey, B. K. Ariga, S. “On-Line Diesel Engine Oil Consumption Measurement” SAE Paper 902113
- Colvin, A. D. Carduner, K. R. Leong, D. Y. Ames, R. Bissell, H. “An Advanced Instrument for the Real Time Measurement of Engine Oil Consumption” SAE Paper 920655
- Schneider, E. W. Blossfeld, D. H. Lechman, D. C. Hill, R. F. Reising, R. F. Brevick, J. E. “Effect of Cylinder Bore Out-of-Roundness on Piston Ring Rotation and Engine Oil Consumption” SAE Paper 930796
- Hanaoka et al. “New Method for Measurement of Engine Oil Consumption (S-Trace Method) SAE Paper 790936
- Hase, Y. Nakajima, Y. Nanbu, S. Murase, I. “Nissan Oil Ecometer Permits the Measurement of Engine Oil Consumption” SAE Paper 810754