This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Framework of DFM Intelligent System for Automotive Body Panel Design
Technical Paper
1999-01-1025
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Design for Manufacture has been applied within the automotive industry. However, high-quality and low cost of production has not been achieved. A preliminary methodology has been established to prevent losing time and cost of production. A structural system has been constructed to provide all aspects of the design that are needed to enable manufacture on the shop floor. This system is aimed at providing advice on the manufacturability at an early stage of the design. It is the intention of this paper to present a preliminary methodology and the benefit of the system will be outline. This research is being carried out at Coventry University and funded by late Mr. Wagimin Suhargianto in Indonesia.
Authors
Citation
Wagimin, D., Blount, G., and Jones, R., "Framework of DFM Intelligent System for Automotive Body Panel Design," SAE Technical Paper 1999-01-1025, 1999, https://doi.org/10.4271/1999-01-1025.Also In
References
- Kishi, N. An Expert System Tool for Automotive Design, International Journal of Vehicle Design, 11 3 1990 272 280
- Wagimin, D. H., Blount, G. N. Prof. Jones, R. M., Dr. An IDEF Analysis of Design For Manufacture of Automotive Body Panels, Paper no. 97VR020, 30 th ISATA Conference ’97, Florence, ITALY, 16th - 19th July 1997
- Wagimin, D. H., Blount, G. N. Prof. Jones, R. M., Dr. Automotive Body Panels Feature Classification Paper no. 98ME009, 31 st ISATA Conference ’98, Dusseldorf, GERMANY 2nd - 5th June 1998
- Wagimin, D. H., Blount, G. N. Prof. Jones, R. M., Dr. Automotive Body Panels Surface Classification Paper no. 982337 , 6 th IBEC ’98, SAE Conference, Detroit, Michigan, USA 29 th September 02 nd October 1998