This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Study on Warm Shot Peening for Suspension Coil Spring
Technical Paper
1999-01-0415
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Warm Shot Peening is a shot peening process within warm temperature range. However, the effect of warm shot peening to fatigue strength was not certain and no substantial study has been made.
The requirements of coil spring with higher fatigue strength and sag resistance have been increasing to obtain the mass saving of vehicle. While several new spring materials have been developed in recent years, the essence of those developments were to make the strength(hardness) of spring higher, so-called high strengthened spring. As for high strengthened spring, the shot peening process becomes further essential to relieve the increased notch sensitivity due to higher strength. However, for the shot peening process to high strengthened spring, the shot with higher hardness is also required. This can decrease the life of both shot and shot peening equipments.
Warm shot peening under the tempering temperature may become one solution to those problems, because the hardness of spring can be temporarily reduced only during the shot peening process. In this paper, the following experimental results concerned with the effect of warm shot peening, are summarized.
- 1The relation between spring fatigue life and hardness under one warm shot peening temperature.
- 2The relation between spring fatigue life and shot peening temperature.
- 3Effects of residual stress, coverage, and surface hardness to fatigue life.
Recommended Content
Technical Paper | Fatigue Life Prediction of Injection Molding Tool |
Technical Paper | Fatigue of Fabricated Steel-Sheet Details-Phase II |
Technical Paper | Fatigue Life Analysis of Automotive V-belt Pulley |
Authors
Citation
Tange, A., Koyama, H., Tsuji, H., and Schaad, J., "Study on Warm Shot Peening for Suspension Coil Spring," SAE Technical Paper 1999-01-0415, 1999, https://doi.org/10.4271/1999-01-0415.Also In
References
- Akutsu T. Tange A. Satoh Y. Arai Y. Iigubo T. Itoh Y. Technical Report of JSSR (Japan Society for Spring Research) Meeting June 1987
- Shimotsusa M. Ibaraki N. Ikeda T. Nakamura T. 1997 Conference Proceedings of The Wire Association International,Inc.
- Nakano O. Sakakibara T. Sugimoto A. Yasuda S. Kusakari W. Watanabe M. Transactions of JSSR 39 1994
- Ohno A. Zairyou sikenn 5 35 1956
- Koyama et al. July 1993
- Koyama et al. November 1993